Sensors have to be installed in the provided brackets. The wires have to be protected against chafing and secured against unintentional removal. Please pay attention to the correct switching distance and the right sensor size.
 
The control of the sensors and the used logic can influence the function of the Lift & Rotate Unit tremendously. This is the responsibility of the operating company.
 
The automatic Lift & Rotate Unit is rotated by a three-phase, geared motor, which has to be controlled by a frequency converter. All sensors for the installed stop unit on the respective configuration must be electrically connected according to the related documentation.
 
In projects or situations where the LOGO!MAT ITB Controls haven’t been ordered, it must be noted that they are not part of the scope of delivery and the controls and related functions and safety control installations of the Lift & Rotate Unit have to be done by the operating company. Since these controls have to meet the needs of our customers, LOGOMAT cannot give any detailed information or specifications to the controls concept.
     
    Lift Rotate Electrical Installation
 
This sketch just represents the sensor locations. Actual unit can be slightly different.
 
To operate the Lift & Rotate Unit as safely as possible, please comply with the following information!
  1. Operating the Lift & Rotate Unit without a pallet in place is forbidden.
  2. The integrated Stop Unit (cushioned) must only move in its home position if the pallet is directly over the Lift and Rotate Unit!
  3. All service and maintenance work must be performed by authorized technical personnel only and must be performed with all energy devices (e.g. electrical or pneumatic power) shut down and secured against reconnection.